Tag Archives: pod

Accu-Tac LR-10 Bipod

Every now and then, I am lucky enough to have the opportunity to try a new piece of equipment. Its a strange place to be, when you have what you think is a perfect fit, and then have to try something different.
That was the case this weekend, when I put the Accu-Tac LR-10 bipod on my SRS Covert. I usually run either a Harris for compact lightweight, or an Atlas 5H for position building perfection. Today my purpose was to give the Accu-Tac a shot, and see how it measured up.
My initial impression when I picked it up, was a bit skeptical. It looked like it was built to be stout, but it also had a bit of a different style to it. Being the complete poser that I am, I pay very close attention to aesthetics. I wasn’t too sure how to feel about the LR-10.
I wasted no time, and quickly put the bipod into use, trying various positions. Like any new piece of gear, it took a second to get used to . But I quickly found myself liking the simplistic operation one would hope to find in two legs attached to a rifle. The QD attachment was smooth and easily adjustable, making installation simple.

Being used to the Atlas and Harris, the LR-10 was an easy shoe in. The few controls on this bipod were quite simple and obvious as to their function. The bipod world has many different options when it comes to leg extending, and I am still undecided about legs springing in, or out. This bipod is of the former, retracting its legs with the simple push of a levered cam. So easy to push in, I was concerned it might be easily pressed by accident causing a loss of sight picture in a heated moment. But to my surprise, the angled cut of the lever uses the weight of the rifle, to create quite a resistance. Making it a deliberate action required to adjust the leg length. Conveniently, when the rifle is not on its legs, all functions of the bipod are very smooth, and require little force. The legs are easily folded by simply pulling them away from the rifle, and positioning them, both front and rear 45 degree angles, as well as the standard 90.

The feet of the bipod screw in, making it easy to change out for spikes vs. rubber.
The extension length of the legs did leave me wanting a bit more. I was surprised they didn’t come out further, considering the size of the un-extended portion.
The pivot point, at the center hub of the bipod has a captured rotation, allowing plenty of cant for uneven terrain, but not allowing the rifle to tip over. A “T” shaped thumb screw is located in the hang down position between the legs. The screw applies pressure to a small brass shoe, that applies a braking force against the shaft on which the bipod cants. The braking force can be adjusted from slight resistance, to completely locked up. While robust in most places, the pivot point of this bipod appears to be the weakest link on this device. I think it would do fine on most rifles, but I would be a bit concerned putting it on heavy recoiling rifles (.33+). I am no engineer, but it does seem to me that a slightly larger shaft could benefit the LR-10.

My impression of shooting with the Accu-Tac was very positive, it was very sturdy. The wide stance, and stout construction made my rifle feel very steady. The quick lockup of the cant feature was easily done with my thumb from the firing position, locking the rifle firmly into place. Setting up position was also quick. By simply rocking the rifle to one side, and pulling down on the downhill leg, followed by a quick leveling, and you are ready to engage. Even under hard bolt manipulation I found it quite easy to keep the rifle on target, and not loose sight picture.
The LR-10 also proved quite stable when shooting from improvised positions, allowing me to really lean into the rifle.

With as many good bipods as there are out there, and as much as some of them cost, I would want to get the best I could for the money. While I dont think I would trade my Atlas 5H in for this LR-10, I do think it is a good product overall. And at almost half the price of the Atlas, the LR-10 is definitely an appealing option for HD bipods. For the average guy who wants a solid rest without spending a huge portion of his earnings, I think this bipod would serve you well. But if you are a tier 1 poser, you may have to step up your gear queer appropriating to a higher level.